Pure white cement-based wall putty for a smooth, paint-ready surface — maximum 3mm application, excellent adhesion to masonry, renders and concrete for premium interior finishes.
What Makes Wall Putty
Stand Out
Pure white cement-based wall putty for a smooth, paint-ready surface — maximum 3mm application, excellent adhesion to masonry, renders and concrete for premium interior finishes.
Made from pure white cement — produces a bright white base that enhances topcoat paint colours and coverage.
Creates an exceptionally smooth, hard surface — ideal substrate for emulsion, texture and designer paint finishes.
Strong adhesion to cement plaster, concrete, brick and masonry — works on all standard interior wall substrates.
Can be applied up to 3mm in a single coat — fills minor surface imperfections for a uniform flat surface.
Once cured, provides resistance to surface moisture — suitable for humid interior environments like bathrooms.
Easy to apply by brush, roller or trowel — workable consistency for smooth application on large areas.
Creates a hard, dense surface layer that resists knocks and impact better than gypsum-based putties.
Low VOC formulation — safe for use in occupied buildings and sensitive environments.
Technologies
Pure white cement base for maximum paint colour accuracy
Creates smooth hard substrate for premium paint finishes
Dense durable surface that outlasts gypsum putties
Fills imperfections up to 3mm in a single application
Where Wall Putty Performs
Interior walls in homes before painting — living rooms, bedrooms, hallways
Office walls, hotel interiors and retail spaces
All new plastered walls before final painting
Existing wall surfaces being re-painted — fills cracks and levels surface
Under premium designer paints, textured finishes and special coatings
Hospitals, schools and sensitive spaces — low VOC safe formula
How to Use Wall Putty
- Surface must be clean, dry and free from dust, grease and loose material
- Remove old flaking paint, efflorescence or loose plaster
- Fill cracks or holes with appropriate filler before putty
- Ensure surface is fully cured — minimum 28 days for new plaster
- Add Zeorich Wall Putty to clean water (W/P ~0.40–0.45)
- Mix with low-speed electric stirrer to smooth lump-free consistency
- Allow 5 minutes slaking then re-stir
- Use within pot life — typically 2–4 hours
- Apply with steel trowel or broad putty knife — maximum 1.5mm
- Allow to dry fully — 4–6 hours minimum, overnight preferred
- Sand lightly with fine sandpaper to remove trowel marks
- Surface should be smooth and consistent before second coat
- Apply second coat to achieve 2–3mm total maximum thickness
- Sand lightly when dry for final smooth finish
- Remove all dust before painting
- Total maximum: 2 coats, 3mm combined
- Allow full 24 hours cure before painting
- Sand with 150–220 grit sandpaper
- Remove all dust
- Apply paint within recommended timeframe for best adhesion
Ideal working temperature +5°C to +35°C. Avoid direct sunlight and extreme temperatures during application.
Always ensure the substrate is clean, dry and structurally sound before application.
Lift a tile to verify adhesive coverage — minimum 65% floor, 80% exterior and wet areas.
Mix only what can be used within the pot life. Do not add water to extend working time.
Do not apply on damp or green plaster. Maximum 3mm per coat — two coats maximum. Allow each coat to fully dry before applying the next.
Technical Data
Coverage varies with substrate condition, tile format and application method. Use our Product Calculator for exact estimates per project.
🧮 Open Calculator →More from Zeorich
PM ScreedPolymer screed binder for floor applications in the Zeorich system
View Product →
SBR Admix
CleanerReady to Build
with the Best?
Download the Technical Data Sheet, use our product calculator, or speak to our technical team for project-specific advice.